Застосування ультразвукових пристроїв у стоматологічній практиці
Валентина Михайлівна Соколовська · Український стоматологічний альманах · 2014
A special place in modern dentistry belongs to efficiency problems in the orthopedic treatment of removable prosthesis, biocompatibility with the tissues of the prosthetic bed. There are still numerous issues as to the lack of durability of prostheses, reducing the residual monomer bases for determining the quality of dentures and their structure. Careful analysis of the literature and some experimental studies of ultrasound have enabled us to offer the technology of ultrasonic processing of polymeric materials. We proposed magnetostrictive ultrasonic unit “UMA-01” own design, which is registered in the State Committee of Ukraine for Technical Regulation and Consumer Policy. The device is designed to prepare the base material for dental prostheses in the initial stage of polymerization of acrylic plastic. For ultrasonic device “UMA-01”, we selected frequency 23.5 kHz because this frequency occurs at least attenuation of ultrasonic waves in passing through the plastic dough and significantly increases efficiency at the lowest energy cost. In addition, the frequency was chosen based on the features of the magnetostrictive transducer, at a certain frequency of the highest amplitude oscillations. Influence of ultrasonic field on polymerization of acrylic plastic was based on the occurrence of variable compression and tensile stresses during the passage of ultrasonic waves. These forces are greater than those that hold the molecules and then between the parts of the monomer and the polymer formed microscopic cavities that are rapidly closing (cavitation), resulting in a significant amount of energy is released, which causes the dissociation and ionization of the surrounding molecules. This feature significantly speeds up the chemical reaction and enables the monomer and polymer rapidly and fully engage in valuable relationship. Due to cavitation, structure of the polymeric material also compacted. This is confirmed by laboratory and clinical studies. Thus, the physical and mechanical properties of samples of basic polymers, manufactured by different techniques polymerization, indicate that the tensile strength and bending from 1.5 to 2 times, as well as their elasticity, is 25% higher in samples that polymerized by ultrasound. The level of residual monomer and the degree of water absorption in the samples that are manufactured with the technical process of polymerization of ultrasound is 50% lower than the specimens made by conventional methods. Ultrasonic processing of polymeric material increases its density by 18%, which significantly improves the physical and mechanical properties of bases dentures and allows you to make them thinner. Thus, the amount of base complete dentures is reduced by 50%, thereby increasing the amount of free space of the oral cavity, which positively affects the process of speech and general adaptation to the prosthesis. In addition, we proposed a way to determine the quality of bases dentures using ultrasonic flaw detector UD2-12 (GOST 2304984) for the first time. It is designed to control plastic products, metal, organic glass and other materials for the presence of defects and for measuring the depth and coordinate their occurrence, measurement of the amplitudes of the signals reflected from defects. We suggested this device to detect the presence of pores and cracks of various kinds of particles and determine the size and depth of the defects in the bulk of dentures.
Cited by 0 works.