대향류 열재생 연소기의 크기와 재료 변화 효과에 관한 실험적 연구

이민정, 조상문, 김남일 · KOSCO SYMPOSIUM 논문집 · 2008

Following the previous experimental study on a base-combustor, half-scale combustors of stainless steel and quartz were fabricated and their flame stabilization conditions were compared experimentally. By the characteristic structure of counter-current channel, unburned gas was heated by burned gas through a middle wall between two channels. The channel gap was less than the ordinary quenching distance of a stoichiometric methane-air premixed flame. Based on the former study, flame stabilizations were classified into four corresponding modes with an ordinary mode, a channel mode, a radiation mode, and a well-stirred reaction mode, respectively. Consequently, a change of the material of the combustor significantly affected the flame stabilization compared to the effects of a scale-down design. And a half-scale quartz combustor had a wide range of flame stabilization condition, and the well-stirred reaction mode was extended. As quartz has lower thermal conductivity, maintaining local heat is relatively easy. By measuring the surface temperature of the combustor, a reference for the choice of a suitable TEM was produced. The combustor surface temperatures ranged from 100 to 550 ℃ in this experiment, and the temperature increased with the flow rate. These results show that the continuous development of a smaller micro-combustor is possible and that the micro-combustor can have wider applicable field.

Cited by 0 works.

Authors