HTS Insert Magnet Design Study
M. Devaux, F. Debray, J. Fleiter et al. · IEEE Transactions on Applied Superconductivity · 2011
Future accelerator magnets will need to reach higher field in the range of 20 T. This field level is very difficult to reach using only Low Temperature Superconductor materials whereas High Temperature Superconductors (HTS) provide interesting opportunities. High current densities and stress levels are needed to design such magnets. YBCO superconductor indeed carries large current densities under high magnetic field and provides good mechanical properties especially when produced using the IBAD approach. The HFM EUCARD program studies the design and the realization of an HTS insert of 6 T inside a dipole of 13 T at 4.2 K. In the HTS insert, engineering current densities higher than 250 under 19 T are required to fulfill the specifications. The stress level is also very severe. YBCO IBAD tapes theoretically meet these challenges from presented measurements. The insert protection is also a critical because HTS materials show low quench propagation velocities and the coupling with the magnet makes the problem even more challenging. The magnetic and mechanical designs of the HTS insert as well as some protection investigation ways will be presented.
Cited by 18 works. doi:10.1109/tasc.2011.2174600
Authors
- M. Devaux
- F. Debray
- J. Fleiter
- Philippe Fazilleau
- Thibault Lécrevisse
- C. Pes
- J.M. Rey
- J. M. Rifflet
- Massimo Sorbi
- Antti Stenvall
- Pascal Tixador
- G. Volpini
References
- Materials at Low Temperatures
- Empirical scaling formulas for critical current and critical field for commercial NbTi
- Status of high transport current ROEBEL assembled coated conductor cables
- Angular dependence of J c for YBCO coated conductors at low temperature and very high magnetic fields
- Angular dependence of critical current properties in YBCO coated tape under high magnetic field up to 18 T
- Design of the EuCARD High Field Model Dipole Magnet FRESCA2
- Benchmark of Two Quench Codes for the Protection Study of an High Field HTS Insert Dipole
- Angular dependence of critical current in YBCO tapes fabricated by inclined substrate deposition