Microstructure-Level Force Prediction Model for Micro-milling of Multi-Phase Materials
Michael P. Vogler, Richard E. DeVor, Shiv Gopal Kapoor · Journal of Manufacturing Science and Engineering · 2003
A mechanistic model for the micro-endmilling process is developed that explicitly accounts for the different phases while machining heterogeneous materials. It is shown that frequencies in the cutting force signal higher than those that can be explained by the kinematics of the process can be explained by considering the multiple phases in the material. Experiments are performed on two compositions of ductile iron, pure ferrite and pearlite workpieces. These experiments show that the nature of the variation in the ductile iron cutting force signals can be attributed to the mixture of the phases. Additionally, simulation studies show that the frequency component of the variation is related to the spacing of the secondary (ferrite) phase and the magnitude of this component is determined by the size of the secondary phase particles.
Cited by 153 works. doi:10.1115/1.1556402
Authors
References
- The Prediction of Surface Accuracy in End Milling
- Mechanism of Cutting Force and Surface Generation in Dynamic Milling
- Modeling micro-end-milling operations. Part I: analytical cutting force model
- Modeling micro-end-milling operations. Part II: tool run-out
- Ultraprecision Machining of SiCw/Al Composites 1 1The Project Supported by National Natural Science Foundation of China
- Microstructure-Level Modeling of Ductile Iron Machining
- Direct fabrication of deep x-ray lithography masks by micromechanical milling
- Modeling micro-end-milling operations. Part III: influence of tool wear
- DEVELOPMENT OF MECHANISTIC MODELS FOR THE PREDICTION OF MACHINING PERFORMANCE: MODEL BUILDING METHODOLOGY
- Machining Simulation of Ductile Iron and its Constituents: Part I — Estimation of Material Model Parameters and Their Validation