Increasing shear force microscopy scanning rate using active quality-factor control
Massimo Antognozzi, Mark D. Szczelkun, Andrew D. L. Humphris et al. · Applied Physics Letters · 2003
The use of an active quality-factor control device has been demonstrated to increase the scanning rate of a shear force microscope by lowering the quality factor of the oscillating probe. Shear force microscopy (often used in combination with scanning near-field optical microscopy) requires slow scanning rates due to the long (>1 ms) time constant of the oscillating element (optical fiber or tuning fork). By electronically reducing the quality factor of the probe, it was possible to tune the time constant and correspondingly reduce the overall scanning time by a factor of 4. It was also seen that probes with high quality factors could manifest an unstable behavior; by reducing the quality factor of the probe, it was possible to increase the signal-to-noise ratio and so improve the imaging resolution. Deoxyribonucleic acid molecules deposited onto mica and imaged in air were used to demonstrate the technique.
Cited by 27 works. doi:10.1063/1.1571233
Authors
References
- Frequency modulation detection using high- Q cantilevers for enhanced force microscope sensitivity
- Combined shear force and near-field scanning optical microscopy
- Parameter control, characterization, and optimization in the fabrication of optical fiber near-field probes
- Dynamic behavior of tuning fork shear-force feedback
- Piconewton regime dynamic force microscopy in liquid
- A phase-locked shear-force microscope for distance regulation in near-field optical microscopy
- Piezo-electric tuning fork tip—sample distance control for near field optical microscopes
- Chemical etching of optical fibre tips — experiment and model
- Melt-drawn scanning near-field optical microscopy probe profiles
- Active Quality Factor Control in Liquids for Force Spectroscopy