Automated parallel high-speed atomic force microscopy
Stephen C. Minne, Goksen Goksenin Yaralioglu, Scott R. Manalis et al. · Applied Physics Letters · 1998
An expandable system has been developed to operate multiple probes for the atomic force microscope in parallel at high speeds. The combined improvements from parallelism and enhanced tip speed in this system represent an increase in throughput by over two orders of magnitude. A modular cantilever design has been replicated to produce an array of 50 cantilevers with a 200 μm pitch. This design contains a dedicated integrated sensor and integrated actuator where the cells can be repeated indefinitely. Electrical shielding within the array virtually eliminates coupling between the actuators and sensors. The reduced coupling simplifies the control electronics, facilitating the design of a computer system to automate the parallel high-speed arrays. This automated system has been applied to four cantilevers within the array of 50 cantilevers, with a 20 kHz bandwidth and a noise level of less than 50 Å. For typical samples, this bandwidth allows us to scan the probes at 4 mm/s.
Cited by 244 works. doi:10.1063/1.121353 Open-access PDF
Authors
- Stephen C. Minne
- Goksen Goksenin Yaralioglu
- Scott R. Manalis
- Jonathan D. Adams
- Jordan Zesch
- A. Atalar
- C. F. Quate
References
- Atomic force microscope lithography using amorphous silicon as a resist and advances in parallel operation
- Low-stiffness silicon cantilevers for thermal writing and piezoresistive readback with the atomic force microscope
- Sequential position readout from arrays of micromechanical cantilever sensors
- 6-MHz 2-N/m piezoresistive atomic-force microscope cantilevers with INCISIVE tips
- Atomic force microscopy for high speed imaging using cantilevers with an integrated actuator and sensor
- High-speed, large-scale imaging with the atomic force microscope
- High-speed scanning tunneling microscopy: Principles and applications
- High-speed atomic force microscopy using an integrated actuator and optical lever detection