3D Vector Forward Modeling
T.Y. Cheng, Olin G. Johnson · Offshore Technology Conference · 1983
ABSTRACT A 3D accoustic wave equation modeling program for the CDC Cyber 20) which has been in development at the University of Houston for two years is now operational. Several test cases have been run involving simple multilayer models. More extensive tests involving more complexity in the geometry of the model are planned. Validation of the model by comparison with tank data is also planned. An overview of the principal features of the computer program is given including a discussion of the use of the SLICE-4 facility of the Cyber 205. Observed times are reported and compared with original estimates. Three dimensional snapshots are presented and discussed. INTRODUCTION The 3D vector forward modeling project was first announced at the May 1981 meeting of the Seismic Accoustics Laboratory Consortium Members (Johnson and Edwards, 1981). The objectives of the project were to compute solutions to 3D problems of size 256 3 spatial points and 30QOtime steps in 10 to 20 hours utilizing the DCD Cyber 205 with eight-way, concurrent I/O. The program is now operational with four-way concurrent I/O and has been run on models of size 512x512x256 (including padding) for several time steps. Although budgetary restrictions have prohibited runs involving 3000 time steps, we can now say that such a run is possible with the present program and will complete in approximately 40 hours. The two-dimensional forward modeling program on the VAX-ll/780 which served as the original basis for this project was reported in (Kosloff and Baysal, 1981). Subsequent progress reports on the CDC effort appear in (Lewitt and Johnson, 1981) and (Cheng, Johnson, Lewitt and Shah, 1982). In the two-dimensional case it takes roughly 10 hours to complete the computations on the VAX-ll/780 with an FPS 100 array processor and takes approximately 11 minutes on the Cyber 205 vector processor. Most of the original design parameters were retained during the course of program development of the 3D model. A few changes were effected. (1) The model size: The size of actual data is 256x256xl28. With padding this becomes 512x512x256. (2) The computing time: The objective was raised to 40 hours with only four-way concurrent I/O. (3) The core memory: Memory requirements were reduced to one million words of central memory. THE FOURIER ALGORITHM FOR THE WAVE EQUATION The 3D acoustic wave equation under consideration is shown in Figure 1. An arbitrary spatial geometry is allowed with density and velocity changes at every point. In practice, it is convenient to treat both functions as constants within a given layer as shown in Figure 2. The Fourier method is used to solve equation (1). Calculations can be divided into two parts:the spatial derivative calculation, andthe time derivative calculation. Fourier transforms are used to calculate the spatial derivatives. Three separate passes are required for each of the spatial directions. Four FFTs are required for each direction. See Johnson and Lewitt (1981) for details of these calculations.
Cited by 1 works. doi:10.4043/4510-ms