Comparison Between Different Design Topologies for Multi-Megawatt Direct Drive Wind Generators Using Improved Second Generation High Temperature Superconductors
Haran Karmaker, Mantak Ho, Devdatta P. Kulkarni · IEEE Transactions on Applied Superconductivity · 2014
Various design topologies were investigated to study the weights and costs for a direct drive wind turbine generator using improved second generation (2G) YBCO high temperature superconductors (HTS). Five different design topologies using combinations of air core, iron core, salient and non-salient configurations for both stator and rotor were considered for a generator with the nominal rating of 10 MW, 8 RPM and 3300 V. The main objective of the investigation was to minimize the HTS quantities and the reduction of total cost to achieve the same rating performance. The electromagnetic design was performed using transient finite element modeling including the improved HTS conductor characteristic properties. The mechanical design includes the support structures for both full load operation and sudden three-phase terminal fault conditions which can cause severe stresses.
Cited by 46 works. doi:10.1109/tasc.2014.2375872
Authors
References
- Trends in Wind Turbine Generator Systems
- 10 MW Class Superconductor Wind Turbine Generators
- A Direct Drive Wind Turbine HTS Generator
- Review of Superconducting Generator Topologies for Direct-Drive Wind Turbines
- 2011 Cost of Wind Energy Review
- Enhanced critical currents in (Gd,Y)Ba2Cu3Oxsuperconducting tapes with high levels of Zr addition
- Installation, Operation, and Maintenance Strategies to Reduce the Cost of Offshore Wind Energy
- Practical Design of a 10 MW Superconducting Wind Power Generator Considering Weight Issue
- Comparison of Conventional and Superconducting Generator Concepts for Offshore Wind Turbines
- Second-Generation HTS Conductor Design and Engineering for Electrical Power Applications