전자제어기의 고속 실시간 모니터링

김건 · 한국자동차공학회 지회 학술대회 논문집 · 2006

A new method for monitoring Electronic Control Units deterministically at a high speed in real-time has been developed. An operating ECU generates a monitoring data packet at each execution cycle right after completing the intrinsic control routines, only if commanded by the monitoring equipment. The monitoring data packet is transmitted through the SPI communication port on the MCU at a maximum transfer rate of 20 Mbps. The ECU operates in master mode and the monitoring equipment operates in slave mode for the high-speed synchronous serial data communication. The SPI communication supports a character length of either 8 bits or 16 bits. The monitoring equipment and ECU are connected to each other through a shielded or unshielded twisted 4-pair cable whose quality is better than CAT5, and the balanced differential interface standard RS-422 is employed between them. It is shown that the interface circuit on the ECU can be implemented simply by using 3 pieces of the RS-422 transceiver along with a set of three resistors consisting of one impedance termination resistor and two open-line failsafe termination resistors. A monitoring data block consists of the user-defined monitoring variables, data types of which may include 8/16/32-bit signed/unsigned integer and 32-bit IEEE-754 floating-point numbers. Two examples are presented to show that this monitoring method can be applied to verify and debug the CPU firmware as well as the electronic circuit of a target embedded system in real-time, when the target embedded system is analyzed with the breakthrough monitoring equipment, Digital LogicScope™.

Cited by 3 works.

Authors

References