인터랙티브 전시물 프로토타이핑 프로세스에 관한 연구

박주용, 문형욱, 조청원 · 한국과학예술포럼 · 2012

In the aspect of recent permanent or non-permanent exhibit, the most important characteristic is that the ratio of interactive exhibit or media increases rapidly. Now that the interactive exhibit causes the continuous interaction by the audiences through mutual communication and induces the thought and behavior altogether by that, it is very efficient regarding education or content delivery. But a number of interactive exhibition media cannot cause various and continuous interactions by the audience and the case that is ended up at single interaction only increases as much of that, however, it was regarded that the biggest reason for such phenomenon occurs is that fully-multilateral test is insufficient against the interaction exhibit. But now that methodology of interaction design that is considered as the alternative to test method tends to focus on the interaction in screen, it is somewhat difficult to apply that to the interactive exhibit. In order to solve such difficulty, prototyping methodology that is the most suitable methodology was inferred through comparative research of design development methodology, software development methodology and hardware development methodology each. But if applies prototyping methodology that takes the repeated test as its basic, the problem that takes the investment of too much time and cost for development of the exhibit, however, the method of applying the open source as the method that solves such problem is thought again, and if it is developed by using the open source that is applicable to development of software and hardware without problem of responsibility, it is expected that numerous number of prototyping tests can be performed without any restriction and the interactivity of the interactive exhibit will be improved and bring out the effect of saving the expenses regarding development of actual exhibit as well. In this paper, production methodology for each field in interaction design, software design, hardware design that are closely related with production of interaction exhibit primarily was looked through, uniform alternative was suggested through prototyping method that is most suitable for the interactive exhibit gained from its result and the suggestion of the open source technology that is applicable to the method, the case that is applied to actual interactive exhibit was analyzed by using prototyping tool and the efficiency of this method was tried to proved by the method that suggests the actual case. It is expected that it would be the foundation as the methodology that is helpful for improving the interactivity of the exhibit and communication with the audience by that.

Cited by 0 works.

Authors

References