Normal Zone Propagation in 2-Dimensional YBCO Winding Pack Models
Woo‐Seok Kim, Frédéric Trillaud, Min Cheol Ahn et al. · IEEE Transactions on Applied Superconductivity · 2008
This paper presents the results of a study of 2-dimensional normal zone propagation (NZP) in winding pack models comprised of 12 straight YBCO tapes stacked with wet, i.e., epoxied, insulating spacers. In each winding pack, the YBCO tapes were connected electrically in series in such a way that a transport current through the YBCO tapes zigzagged from one end of the winding pack to the other end of the winding pack. An insulated heater strip placed at the middle of the stack was energized to trigger a quench in YBCO tapes with a combination of heater taps which permits the length of the heated section to be varied for 1- or 2-dimensional NZP. Voltage taps of various lengths were placed within the winding packs to measure the transverse and longitudinal NZP speeds. Measurements with wet-spacers in which a large contact thermal resistance at each YBCO tape and spacer interface is chiefly responsible for very slow transverse NZP velocities, effectively eliminate the interface thermal resistance, resulting in faster transverse NZP speeds. Numerical simulation that neglects interface thermal resistance agrees quite well with experiment.
Cited by 31 works. doi:10.1109/tasc.2008.922344
Authors
References
- Superconducting magnets
- Case studies in superconducting magnets
- Measurements of temperature dependence of the stability and quench propagation of a 20-cm-long RABiTS Y-Ba-Cu-O tape
- Normal zone propagation experiments on HTS composite conductors
- Stability and Quench Protection of Coated YBCO “Composite” Tape
- Normal Transition and Propagation Characteristics of YBCO Tape
- Stability and Protection of Superconducting Magnets—A Discussion
- Normal Zone Propagation in YBCO Winding Pack Models
- Normal zone propagation characteristics of the HTS wires by heat energy applied
- Quench Propagation Characteristics of the Liquid Nitrogen Cooled HTS Wires by Externally Injected Heat Energy