전자제어기의 개발에 적용된 디지털 로직스코프

김건 · 한국자동차공학회 Symposium · 2006

The new high-speed real-time monitoring equipment, i.e. Digital LogicScope, that can be employed during the design and development phases of Electronic Control Units has been developed. An operating ECU generates a monitoring data packet at each execution cycle right after completing the intrinsic real-time control and CAN communication processes, only if commanded by the digital LogicScope. The monitoring data packet is transmitted through the SPI communication port on the MCU at a maximum transfer rate of 20 Mbps. The ECU operates in master mode and the digital LogicScope operates in slave mode for the high-speed synchronous serial data communication. The SPI communication supports a character length of either 8 bits or 16 bits. The digital LogicScope and ECU are connected to each other through a shielded or unshielded twisted 4-pair cable whose quality is better than CAT5, and the balanced differential interface standard RS-422 is employed between them. It is shown that the interface circuit on the ECU can be implemented simply by using 3 pieces of the RS-422 transceiver along with a set of three resistors consisting of one impedance termination resistor and two open-line failsafe termination resistors. A monitoring data block consists of the user-defined monitoring variables, data types of which may include 8/16/32-bit signed/unsigned integer and 32-bit IEEE-754 floating-point numbers. Four examples are presented to illustrate that the digital LogicScope can be applied to verify and debug the CPU firmware as well as the digital electronic circuit of a target embedded system in real time.

Cited by 3 works.

Authors

References