딤플/돌출이 설치된 사각채널에서의 열전달 및 압력강하 특성에 관한 실험적 연구
황상동, 권현구, 조형희 · 대한기계학회 춘추학술대회 · 2005
An experimental study was conducted to investigate the heat transfer and pressure drop of a rectangular channel with the dimpled and/or protruded walls. And the effects of complex geometries of dimple and protrusion on heat transfer and pressure drop were investigated. In the present study, three different roughened surfaces of dimpled, protruded and complex(dimple-protrusion) surface were tested. The dimples/protrusions were installed at both top and bottom walls of the rectangular duct. The dimple depth is 0.25 times dimple diameter(D) and the protrusion height is also 0.25D. The dimple or protrusion has staggered array pattern, and the complex case has the pattern of repeat of the rows of dimples and protrusions. The local heat transfer coefficients on the dimpled/protruded walls were measured using a transient TLC(Thermocromic Liquid Crystal) technique. The friction factors of the rectangular channel with dimples/protrusions were obtained using pressure taps installed at the channel side wall. And the performance factors, which indicate the enhancement levels by both considerations of heat transfer enhancements and pressure loss increases were evaluated. As a result, high heat transfer region appeared at the rear side of the dimple due to the increased flow mixing on the dimpled surface. For the protruded surface, heat transfer was enhanced on the front side of the protrusion by the impingement effects of the flow induced by the horseshoe vortices. In case of complex geometry, dimple-protrusion, the compound effects of the dimple and protrusion occurred. The protrusion case showed the highest heat transfer enhancement among test cases. However, pressure loss increased. For the performance factor, the dimple case shows the highest performance factor among tested cases due to the slightly low pressure drop increase.
Cited by 0 works.