Информационно-измерительные системы на основе микромеханических датчиков
В А Солдатенков, Ю К Грузевич, Ачильдиев Владимир Михайлович et al. · Лесной вестник / Forestry bulletin · 2015
Various MEMS gyroscopes and accelerometer based devices, namely inclinometers for different applications, the system for weighing the load of the trucks and on-board measuring system for controlling the motion parameters of the vehicle have been researched. The flowcharts of the described devices are provided, as well as their appearance and mathematical models. The expressions for calculation of the slope angles while the measured values of the acceleration vector of free fall on sensitivity axis are given, the technical characteristics of the developed inclinometers are provided. The cargo measurement system in the body of the vehicle consists of three inclinometers a front peripheral inclinometer, a rear peripheral inclinometer and a base inclinometer, the connection unit and an onboard computing unit of the system. The CAN inclinometers are connected to the bus network through the connection unit which is linked to the onboard computing unit. A peripheral inclinometer is installed on the frame of the vehicle at a point forward of the maximum front deflection of the frame, and rear peripheral inclinometer is installed at a point forward of the maximum back deflection of the frame. A base inclinometer is installed at the point of the minimum deflection of the frame. An onboard measuring system for controlling the motion parameters of the vehicle is intended for measuring the parameters of the moving vehicle: linear acceleration, angular velocity, speed, coordinates, cyclic recording of the measured parameters and transmission to the remote control or external drive for subsequent processing. The recorded data is used to recover the spatial trajectory and for the analysis of the causes of road accidents, determining the current vehicle location on the route or in case of theft of the vehicle. In addition, the system allows to determine the geometric parameters of the road (slope, the radii of curvature of the roadway and the pavement quality (evenness, pits, grip) by processing the measured values of the projections of the linear accelerations and angular velocities.
Cited by 0 works.