Монтажные особенности ножевых валов широкопроходных мездрильных машин
Афанасьев Виктор Владимирович, Байкин Сергей Дмитриевич, Иванов Владимир Александрович · Интернет-журнал Науковедение · 2015
This article presents analysis of conditions for the feasible reduction in vibration loading level of the full-hole fleshing machines through the use of valid choice of the supporting unit design, type of frictionless bearings and methods of their installation and erection in the case. We have studied the problems of accuracy figure choice for the bearing supports of full-hole rolls and analyzed the pattern of support part wear, which can cause the relative turning of bearing rings after achievement of a defined level, especially at the initial moment of movement and acceleration of shafting. The current angle of turning one of the bearing rings erected with insufficient interference increases, especially in the time of frequent startups and shutdowns of machines for demounting roll (with opportunity of its replacement) due to need of the wearable screw knife change. This process causes the current geometry malfunction of the working surfaces of the support unit elements, resulting in intensified wear of the roll mating surfaces during their fitting. The reason for this is that the fleshing roll necks have insufficiently high hardness whereby change of the roll rotation accuracy takes place, in particular due to the dynamic unbalance of roll, followed by intensified wear of the bearing elements.
Cited by 0 works.