자외선 레이저를 이용한 고정밀 저항체 가공기술 개발

노상수, 김동현, 정귀상 et al. · 센서학회지 = Journal of the Korean Sensors Society · 2002

본 논문에서는 백금박막 온도센서의 $0^{\circ}C$ , $100{\Omega}$ 세팅을 위해 355nm 파장을 갖는 자외선 레이저를 이용하였다. 국제적으로 온도센서의 A-class 기준오차는 $0^{\circ}C$ 에서 ${\pm}0.060{\Omega}$ 이다. 실제적으로 이 값은 $0.15^{\circ}C$ 이하에 해당하는 오차로 저항체 제작시 고정밀 가공 기술을 필요로 한다. 가공에 이용된 355nm DYP(Diode-Pumped YAG) 레이저는 power : 37mW, rep rate 주파수 : 200Hz 그리고 bite size : $7.5{\mu}m$ 에서 $1{\sim}1.5{\mu}m$ 두께의 백금박막을 가장 안전하게 가공할 수 있었으며, 가공선폭은 $10{\mu}m$ 안팎임을 확인하였다. 그리고 사진식각 공정기술을 이용하여 제작된 $2{\times}2$ 기판내의 96개(4 by 24) 저항체는 상온 $25^{\circ}C$ 에서 $79{\sim}90{\Omega}$ : 42.7%, $91{\sim}102{\Omega}$ : 57.3%의 비율로 각각 제작되어졌다. $109.73{\Omega}$ 를 목표 값으로 $25^{\circ}C$ 에서 자외선 레이저를 이용하여 가공한 결과, 82.3%가 가공오차가 ${\pm}0.03{\Omega}$ 이하에 들어왔으며 나머지 17.7%도 국제규격 A-Class내인 ${\pm}0.06{\Omega}$ 내에 포함되었다. 【In this paper, we used U.V.(wavelength, 355nm) laser for adjusting Pt thin films temperature sensor to $100{\Omega}$ at $0^{\circ}C$ . Internationally, A-class tolerance of temperature sensor is $0.06{\Omega}$ at $0^{\circ}C$ . This is under value of $0.15^{\circ}C$ , actually, so high-fine trimming technology is essential to this process. The width of trimmed lines was about $10{\mu}m$ and the best trimming of Pt thin films of $1{\sim}1.5{\mu}m$ was carried out with power : 35mW, rep. rate frequency : 200Hz and bite size : $1.5{\mu}m$ . And using photolithography process, 96 resistors were fabricated in $2{\times}2$ substrate as the proportion of $79{\sim}90{\Omega}$ and $91{\sim}102{\Omega}$ is 42.7% and 57.3%, respectively. As result of trimming resistors to the target value of $109.73{\Omega}$ at $25^{\circ}C$ , 82.3% of resistors had the tolerance within ${\pm}0.30{\Omega}$ and the others(17.7%) were within ${\pm}0.06{\Omega}$ of A-class tolerance.】

Cited by 0 works.

Authors