압연 중 핀홀 결함의 변형 이력의 추적

남찬희, 진호태, 손일헌 et al. · 한국소성가공학회 학술대회 논문집 · 2014

In this paper, two-dimensional finite element approach of prediction the plastic deformation of tiny pinhole defects on the initial bloom surface, which were formed during continuous casting process of the base material of bloom. The initial pinhole shapes of which plastic deformations are to be traced are assumed V-shaped and U-shaped. Two different kinds of pass schedule of consecutive rolling stages are assumed to investigate the defect closing or lapping behaviors, i.e., one pass schedule of two forward rolling stages and another pass schedule of reverse rolling stage after forward rolling stage. The dimensions of the processes and the sizes of pinholes are also assumed to reflect the actual three-dimensional rolling processes. It has been shown that most plastic deformation occurs at the entry side and lapped or closed defects slightly open when they pass through the exit side. It is noteworthy that the reverse rolling decreases the lapped defect formed in the previous pass, implying that there exists an optimized pass schedule design to minimize the surface defect.

Cited by 0 works.

Authors