ПРИМЕНЕНИЕ ТЕОРИИ ПЛАСТИЧНОСТИ ДИЛАТИРУЮЩИХ СРЕД К ПРОЦЕССАМ УПЛОТНЕНИЯ ПОРОШКОВ МЕТАЛЛИЧЕСКИХ СИСТЕМ
Е. П. Макаров, Alexander Evgenievich Gvozdev, Г. М. Журавлев et al. · Чебышевский сборник · 2018
The authors carried out the basic parameters calculation of compacting powders of metallic systems (metals, steels, non-ferrous alloys of different alloying systems) during plastic compression deformation. The paper considers variants of calculating the pressures and densities distribution in powder compacts of various cross sections in different coordinate systems. The authors found that the highest density of the rectangular cross-section powder compact after pressing is observed near a die wall under the pressing punch, at the middle of the short side of the rectangle the density is higher than in the middle of the long side; the lowest density is observed at the die wall above the fixed punch, and in the middle of the short side of the rectangle the density is lower than in the middle of the long side; the lowest density under the pressing punch and the highest density over the fixed punch are observed at the centers of the corresponding rectangular sections. It is shown that in elliptical section compacts of the powders of metal systems after pressing at positive value ζ (ζ > 0) the pressure and density at the ends of the ellipse major axis are higher than at the ends of the minor axis and, conversely, when the ζ < 0 pressure and density at the ends of the major axis are less than at the ends of the minor axis. The obtained results can be used to develop low-waste and resource-saving processes and technologies for processing industrial materials under various conditions and states.
Cited by 4 works. doi:10.22405/2226-8383-2017-18-4-268-284 Open-access PDF
Authors
- Е. П. Макаров
- Alexander Evgenievich Gvozdev
- Г. М. Журавлев
- Александр Николаевич Сергеев
- Igor Vasilyevich Minaev
- Alexander Dzhalyulyevich Breki
- Dmitry Vladimirovich Maliy
References
- Approximate Calculation of Integrals.
- Multiparametric optimization of laser cutting of steel sheets
- Temperature distribution and structure in the heat-affected zone for steel sheets after laser cutting
- Features of softening processes of aluminum, copper, and their alloys under hot deformation
- On friction of metallic materials with consideration for superplasticity phenomenon
- Synthesis and dry sliding behavior of composite coating with (R–OOO)FT polyimide matrix and tungsten disulfide nanoparticle filler
- Grain size effect of austenite on the kinetics of pearlite transformation in low- and medium-carbon low-alloy steels
- Composite coatings based on A–OOO polyimide and WS2 nanoparticles with enhanced dry sliding characteristics
- Burnishing with wear-resistant mineral–ceramic and hard-alloy indenters
- Maximum plastic strengthening in tool steels