A Variable Dynamic Range Single-Photon Imager Designed for Multi-Radiation Tolerance
Lucio Carrara, Matthew W. Fishburn, Cristiano Niclass et al. · 2009
We present new measurements conducted on a single-photon imager implemented in CMOS technology. The sensor was designed to sustain massive doses of Gamma irradiation, X-rays, and proton bombardment. The chip was also designed to operate continuously in large magnetic fields without measurable noise and distortion. The imager consists of an array of 32x32 photon counting pixels with a pitch of 30µm. Each pixel comprises a single-photon avalanche diode (SPAD) based on [1], a 1-bit counter, and miniaturized readout electronics. The chip measures 2.00x2.35mm 2. The block diagram and a photomicrograph of the sensor are shown in Fig. 1. The pixel array is read out in rolling shutter mode via the high-speed row decoder and may be reset after each read operation or read out non-destructively. Fig. 1. Block diagram of the sensor (left). Photomicrograph of the sensor system and pixel inset (right).2 All 32 columns are read in parallel, thus enabling a complete 1024-pixel frame readout in Tmin =1.2µs with 1-bit depth. To achieve a higher number of gray levels we accumulate N frames, thus reaching an intensity resolution of log2(N) bits at the expense of lower frame rates. The saturation count rate is 1/Tmin, SNRmax for integration time tint is computed as SNRmax = 20log t " %
Cited by 0 works.
Authors
References
- Design and characterization of a CMOS 3-D image sensor based on single photon avalanche diodes
- Single-Photon Synchronous Detection
- Design and characterization of ionizing radiation-tolerant CMOS APS image sensors up to 30 Mrd (Si) total dose
- 100 kframe/s 8 bit monolithic single-photon imagers
- A gamma, x-ray and high energy proton radiation-tolerant CIS for space applications
- Radiation-induced dark current increase in CMOS active pixel sensors