ТЕОРЕТИЧНЕ І ЕКСПЕРИМЕНТАЛЬНЕ ВИЗНАЧЕННЯ УМОВ ЗМЕНШЕННЯ ШОРСТКОСТІ ПОВЕРХНІ ПРИ АБРАЗИВНІЙ ОБРОБЦІ

Олександр Сергійович Сергєєв, Олександр Олександрович Анділахай · Наука та виробництво · 2019

Analytical dependences for determination of height parameters of surface roughness are presented when using the method of proving bound abrasive with single-layer arrangement of abrasive grains on the working surface of the tool. Patterns of formation of surface roughness are described analytically taking into account the probable participation of grains in cutting and taking into account their wear. It is shown that with the transition from the conical shape of the working part of the cutting grains to the spherical shape (due to wear of the grains), the height parameters of the surface roughness Ra and Rmax decrease. The ratio, on the contrary Rmax / Ra , increases due to a more intense decrease of the parameter compared to the decrease of the parameter Rmax . On this basis, certain conditions for reducing the surface roughness parameters, which consist in reducing the grain size of the abrasive and increasing the number of simultaneously working grains. The obtained theoretical solutions are confirmed experimentally. On this basis, an effective technology of internal grinding of holes in cylinders with a soft felt (felt) wheel with a pasted layer of abrasive powder 63C grit F150 – F180 is developed. The application of this technology can significantly reduce the surface roughness parameter Ra (to a value of 0.1 microns and less) without increasing the complexity and reducing processing performance. The double positive effect is achieved, first of all, due to the fact that the processing risks of further processing in the considered technology are directed at a right angle to the processing risks obtained in the previous operation, with the cutting speed (grinding) is much higher than the cutting speed (grinding), eg grinding, , when honing. In addition, the additional positive effect is that the machining risks remaining after grinding with a soft felt (felt) wheel with a bonded layer of abrasive powder coincide in the direction with the movement of the piston of the pneumatic cylinder, which ensures the preservation of the piston rings or other seals of the piston.

Cited by 0 works. doi:10.31498/2522-9990212019189920 Open-access PDF

Authors