ВЛИЯНИЕ УГЛЕРОДНЫХ ВОЛОКОН НА ТРИБОЛОГИЧЕСКИЕ СВОЙСТВА ПОЛИЭФИРЭФИРКЕТОНА

А. И. Буря, Н. Т. Арламова, Anna-Mariia Tomina et al. · Наукові праці. Серія: Техногенна безпека · 2016

Polyetheretherketones (PEEK) are aromatic polymers with monomolecular chains built of phenylene rings, the carbonyl groups and oxygen atoms. PEEK has a unique complex of operational properties (deformation heat resistance, flame resistance, radiation resistance, low water absorption, dielectric and structural properties), which stimulated their development and application, despite the complexity of processing (processing temperature ranges 320–400 °С) and high cost. A distinctive feature of PEEK–its extremely high moisture resistance, including resistance to hot water and steam. Due to these properties it ranks over all known thermoplastics, including polyether sulphone and polyphenylene sulphide. PEEK has administered discrete carbon fibre (CF) to improve its performance.We developed filled compositions containing 5–20 mas. % of CF on the base of PEEK. The press – compositions containing of: PEEK + 5–20 mass. % carbon fibre of «Toreyka» brand were prepared by mixing the components in a rotating electromagnetic field in the presence of ferromagnetic particles. Processing of this prepared mixture into block articles was carried out by method of compression press moulding. The structure of materials was studied in the scanning electron microscope of high resolution JEOL JSM – 6460 LV cylindrical specimens h = 3 ÷ 5,  = 15 mm. Research of tribological properties (wear, friction coefficient and temperature in a contact zone) in the mode of dry friction carried out by disk car friction on a film of transfer and on an initial surface of a counte – body. For researches used samples diameter of 10 mm and height of 12 mm. Considering that one of primary branches of use of the developed carbon plastics is the mechanical engineering, in particular details of mobile joints – the special attention has been paid to studying the tribological characteristics as it gives an opportunity to predict the loading capacity of the frictional unit completed with details from carbon plastics. The analysis of results demonstrates that reinforcing PEEK of CF is followed by significant improvement of tribotechnical characteristics. In particular, at introduction of 5–15 mass.% the fiber in a polymeric matrix the friction coefficient decreases during the work of samples together with an initial steel surface and in the presence on her transfer films in 1,14–1,67 and 1,8–1,9 times, respectively. As for wear, it decreases still to a large extent, namely in 7,5–8,9 and 1,1–4,1 times, respectively. On the one hand, it is explained by higher strength properties developed unitary enterprise, than at initial PEEK; with another – they have 1,3–1,7 times above heat conductivity that, according to the fatigue theory of wear prevents localization of heat in a friction zone and thermomechanical destruction of polymers. Concerning quantity of CF, it is possible to note that the maintenance of 10–15 mass. % is optimum. Increase in amount of fiber in composite up to 20 mass. % leads to deterioration in the studied characteristics that apparently is caused by a loosening of composites on the boundary of polymeric binding – carbon fiber

Cited by 0 works.

Authors