Определение модулей упругости третьего порядка в образцах полистирола, изготовленных по разным технологиям
Andrey V. Belashov, Anna A. Zhikhoreva, Я.М. Бельтюков et al. · Журнал технической физики · 2021
An ultrasonic method was applied in this work to measure third-order elastic moduli of polystyrene samples fabricated using different technologies: two commercial samples of a styrene copolymer with ethylene glycol dimethacrylate in different concentrations and two laboratory samples obtained by melt technology in different temperature regimes. It is shown that the dependences of nonlinear elastic moduli on the frequency of ultrasonic waves in the range of 1-3 MHz differ significantly between commercial copolymer samples and laboratory samples. The moduli of laboratory samples obtained using the same technology, but in different temperature regimes, also differ markedly. Thus, the manufacturing technology can affect significantly the nonlinear elastic properties of polymer materials.
Cited by 0 works. doi:10.21883/jtf.2021.08.51094.22-21 Open-access PDF
Authors
References
- Finite Deformation of an Elastic Solid
- Second-Order Elastic Deformation of Solids
- Experimental characterization of material nonlinearity using Lamb waves
- Measurement of the thermal glass transition of polystyrene in a cooling rate range of more than six decades
- Splitting induced generation of soliton trains in layered waveguides
- Comparison of the effect of cyanoacrylate- and polyurethane-based adhesives on a longitudinal strain solitary wave in layered polymethylmethacrylate waveguides
- Nonlinear elastic properties of solid polymers as revealed by Brillouin spectroscopy
- Polystyrene-Based Nanocomposites with Different Fillers: Fabrication and Mechanical Properties
- Measurement of third-order elastic constants and applications to loaded structural materials
- Relative variations of nonlinear elastic moduli in polystyrene-based nanocomposites