Экспериментальное исследование и математическое моделирование поверхностного эффекта проводника с током в ферромагнитном пазу
Захарова Наталья Васильевна, Татевосян Александр Сергеевич · Электротехнические и информационные комплексы и системы · 2013
The results of an experimental study of the electromagnetic field in a ferromagnetic groove on the basis of the developed laboratory bench, equipped hardware and software measuring complex, and numerical simulation of an alternating electromagnetic field through program’s complex Elcut 5.6 (professional version) are in the article. The structure of the laboratory bench are: • a physical model of the groove is strapped of bolts extruded sheets of transformer steel. The depth of the groove is 50 mm, it’s width 5 mm. Copper bar ( conductor) is located in a ferromagnetic slot, conductor’s crosssectional area is 50 х 2,5 mm 2; • power section is a step-down transformer, a flexible conductor, current-limiting resistor (fan cooled nichrom’s heating element), a network switch; • measuring part hardware and software measuring complex with the developed software application Surface effect in a ferromagnetic slot in a visual programming environment Borland Delphi 7.0 that is associated through technology ActiveX with area of LabVIEW, USB oscilloscope BM8020, milliteslametr TPU-02, pickup coil, digital voltmeter, a current transformer (TT), measuring resistance (current sensor). Implemented method for determining the current density in the cross section of the conductor by measuring the magnetic field immersion of two sensor types (frameless thin pickup coil and Hall sensor digital milliteslametra) at different depths inside the groove. Using as a measuring coil in the sensor can obtain the current density distribution adjustment of the conductor through the integration procedure voltage proportional to the induced electromotive force in the measuring coil from the digital integrator, built in the medium LabVIEW. Measuring the magnetic field Hall effect sensor digital milliteslametra in laboratory bench allows you to perform verification of the measuring coil and determine the reliability of the results of the pilot study. With the help of software and measuring complex on a laboratory bench, the distribution of current density and magnetic induction on the height of the ferromagnetic conductor groove. The results of experimental studies of the surface effect compared with the results of calculation of the alternating magnetic field of a conductor with a current in the ferromagnetic groove in complex programs Elcut 5.6, determined active and inductive resistance of the conductor at the power frequency.
Cited by 0 works.