Измерение нестационарного теплового потока в экспериментах на ударных трубах с помощью датчиков на основе анизотропных термоэлементов из висмута
П.А. Попов, Н.А. Монахов, T. A. Lapushkina et al. · Журнал технической физики · 2022
An analysis of main features of unsteady heat flux measuring in shock tubes experiments with a characteristic process time of ~1 μs - 1 ms using sensors based on anisotropic bismuth thermoelements is made. The heat flux behind the reflected shock wave and at the blunt body stagnation point has been measured. Testing of the heat flux calculation method was carried out. The difference between the experimental data and the theoretical value of the heat flux does not exceed 50%. The possible reasons influencing the magnitude of measurement uncertainty are analyzed. The experiments performed have shown the applicability of a sensor based on anisotropic thermoelements and the method for calculating the heat flux from its electrical signal for typical conditions of experiments on shock tubes.
Cited by 2 works. doi:10.21883/jtf.2022.09.52924.54-22 Open-access PDF
Authors
References
- Theory of Stagnation Point Heat Transfer in Dissociated Air
- NASA Glenn Coefficients for Calculating Thermodynamic Properties of Individual Species
- Theory of heat transfer to a shock-tube end-wall from an ionized monatomic gas
- Stagnation-Point Heating in Ionized Monatomic Gases
- Novel Sensor for Fast Heat Flux Measurements
- Effect of Magnetohydrodynamics Interaction in Various Parts of Diffuser on Inlet Shocks: Experiment
- A coaxial thermocouple for shock tunnel applications
- Double-diaphragm shock tube at the Ioffe Physicotechnical Institute
- A Novel Sensor for Fast Heat Flux Measurements
- MHD Control of the Separation Phenomenon in a Supersonic Xenon Plasma Flow II