Методика исследования течения миниатюрной кумулятивной струи из меди
Мелёхин Николай Владимирович, А. М. Брагов, Н. Н. Берендеев et al. · Журнал технической физики · 2022
A novel experimental laboratory technique for the flow of miniature cumulative jet of copper and without using explosives, is described. To perform the microcumulative tests, miniature cylindrical specimens with conical pits were used. The dynamic loading of the specimens was performed using a gas gun with a striker accelerated up to speeds of 800 m/s. The optimal specimen geometry and testing regimes, including the focal distance during microcumulation testing, were then determined. The influence of the structural condition of the sample material on the parameters of the cumulative jet has been demonstrated A preliminary analysis of the effects of copper purity and processing regimes on the ultimate dynamic plasticity characteristics was performed.
Cited by 0 works. doi:10.21883/jtf.2022.11.53440.122-22 Open-access PDF
Authors
References
- Fracture characteristics of three metals subjected to various strains, strain rates, temperatures and pressures
- An Investigation of the Mechanical Properties of Materials at very High Rates of Loading
- Dynamic Behavior of Materials
- A constitutive model for metals applicable at high-strain rate
- The use of flat-ended projectiles for determining dynamic yield stress I. Theoretical considerations
- Hopkinson bar experimental technique: A critical review
- Observation of an adiabatic shear band in titanium by high-voltage transmission electron microscopy
- Dynamic recrystallization of tungsten in a shaped charge liner
- Introduction to Impact Dynamics
- A comparison of shaped charge liner cone and recovered jet fragment microstructures to elucidate dynamic recrystallization phenomena