ПОВЫШЕНИЕ ЭФФЕКТИВНОСТИ РАБОТЫ ПАХОТНОГО МАШИННО-ТРАКТОРНОГО АГРЕГАТА

Е.С. Поликутина, Sergey Vasilievich Shchitov, Zoya F. Krivutsa et al. · The Bulletin of Izhevsk State Agricultural Academy · 2025

Процесс подготовки почвы к посевным работам является основным этапом для получения хорошего урожая. В последние годы наибольшее распространение получил безотвальный способ подготовки как наименее энергозатратный, что важно для снижения себестоимости возделываемой сельскохозяйственной культуры. В Амурской области основной возделываемой культурой остается соя, а поздние сроки ее уборки не позволяют подготовить почву к посевным работам осенью. В связи с этим повсеместно для этой операции используются дисковые орудия, способные более производительно подготавливать почвы, что важно при ограниченных агротехнологических сроках проведения весенних полевых работ. Безотвальный способ подготовки почвы создает предпосылки к образованию «плужной подошвы», а это ведет к нарушению ее водно-воздушного баланса, что сказывается на росте и развитии сельскохозяйственных культур. Это явление характерно для тех регионов, где наличие мерзлотного основания затрудняет отвод избыточной влаги в нижние слои почвенного горизонта. Поэтому для улучшения водно-воздушного баланса необходимо использовать такой способ подготовки почвы, как вспашка. При выполнении данной операции наблюдается отклонение пахотного машинно-тракторного агрегата от траектории прямолинейного движения за счет возникновения дополнительных сил, которые вызывают появление поворачивающего момента, воздействующего на управляемые передние колеса энергетического средства. Для снижения этого явления предлагается использовать устройство «корректор-стабилизатор при работе с навесным плугом», позволяющее стабилизировать траекторию движения пахотного машинно-тракторного агрегата. The process of preparing the soil for sowing is the main stage for a good harvest. In recent years, the subsoil tillage has become the most widespread method of preparation as it is the least energy-consuming, which is especially important for reducing the cost of cultivated crops. In the Amur Region, soybean is the main cultivated crop, and the late dates for its harvesting do not allow preparing the soil for sowing in the fall. In this regard, disc tools capable of more efficient soil preparation are widely used for this operation, which is especially important since the agrotechnological timing of spring field work is limited. At the same time, the subsoil tillage creates the prerequisites for the formation of a ‘plow sole’, and this leads to a violation of the water-air balance of the soil, which further affects the growth and development of crops. This is especially typical in those regions where the permafrost base already makes it difficult to remove excess moisture to the lower layers of the soil horizon. Therefore, to improve the water-air balance, it is necessary to use such method of soil preparation as plowing. When performing this operation, there is a deviation of the plowing machine and tractor unit from the trajectory of rectilinear movement due to the occurrence of additional forces that cause the appearance of a turning moment affecting the controlled front wheels of the energy device. To reduce this phenomenon, it is proposed to use the corrector-stabilizer during work with a mounted plow, which allows stabilizing the trajectory of the plowing machine and tractor unit.

Cited by 0 works. doi:10.48012/1817-5457_2025_3_171-178 Open-access PDF

Authors