Експериментально-теоретичне дослідження роботи буронабивних мікропаль на дію вертикальних вдавлюючих навантажень
О. П. Гнатюк, В. М. Максимович, T. Yu. Osadchuk et al. · Сучасні технології та методи розрахунків у будівництві · 2025
For a long period, the research laboratory of the Department of Building Structures of the LNUVMB named after S. Z. Gzhitsky carried out experimental studies of the load-bearing capacity of drilled reinforced concrete piles with a spread heel, developed and implemented in real practice together with PP "BKF" Osnova" during the last 10-15 years [1-6]. In accordance with the existing methods of theoretical calculation, the load-bearing capacity of piles in general depends on two components: on the resistance of the soil of the base under its lower end (heel) and on the friction on the side surface of its trunk [7]. In order to experimentally verify this dependence, 3 prototypes of MP-1, MP-2 and MP-3 micropiles were manufactured at the experimental range of the Department of Building Structures. All studied samples were made in pre-drilled wells by the auger drilling method in wells with a diameter of 200 mm with a depth of 3 m, but of different construction. The MP-1 micropile was manufactured without propagation with an elastic pillow 100 mm thick inserted into the butt; MP-2 - with a spread heel with a diameter of 350 mm, also with the arrangement of an elastic cushion under it with a thickness of 100 mm; MP-3 - in a casing inventory pipe with a diameter of 200 mm, with a common heel with a diameter of 350 mm without an elastic cushion. Experimental studies were carried out according to the scheme of static vertical indentation by the method of step-increasing loading [8]. The vertical movement of the upper head of the experimental samples of micropiles by more than 4 cm was accepted as a strength criterion. As a result, it was established that according to this criterion, the load-bearing capacity was 52.5kN for micropiles MP-1 and 57.5kN for MP-2, 85kN for MP-3. A theoretical calculation of the settlement of experimental samples of micropiles was also carried out in accordance with the instructions [7]. A comparative analysis of data based on tables and graphs showed that the load-bearing capacity (deformability) according to the experimental data exceeds the theoretical calculation results by 29% for MP-1, 32% for MP-2, and 37.5% for MP-3.
Cited by 0 works. doi:10.36910/6775-2410-6208-2025-14(24)-09