下肢の支持性が低下した人に対する移乗サポートロボットを用いての立ち上がり動作の検証
君和 伊丹, 寿彦 安田, 久美子 豊田 et al. · Institutional Repositories DataBase (IRDB) · 2005
Background The graying of the Japanese society and the increase in the number of people seeking assistance to carry out some of the basic everyday activities have resulted in an increased incidence of low back pain among nurses and caregivers. Assisting individuals particularly in transferring into and out of a wheelchair puts a lot of strain on the low back. This is true not only for nurses but also for those individuals caring for a family member with support needs. In order to prevent low back pain among nurses and caregivers, it is imperative that a range of transfer aids (such as, lifts and robots) be developed and utilized. At the same time, individuals with support needs should be provided with the means to achieve independence in daily living activities. Objective This study was conducted to analyze electromyographic (EMG) activity during a robotassisted standing transfer in individuals with reduced lower limb strength. A standing transfer consists of moving from a seated to a standing position. An experimental robot, which was designed to assist people in standing transfers, was used. Subjects were surveyed regarding the usability of the robot and the subjective response associated with a robot-aided standing transfer. Based on the results obtained from the experiment and the survey, practicability of the robot as a transfer aid was evaluated in terms of user safety and comfort. Method 1. Subjects and Methods: The following experiment and survey were conducted in March, 2004. Subjects were four male university students and four female university students who had been trained to simulate individuals with reduced lower limb strength. In the experiment, the robot was first placed very close to the subjects, who were asked to lean on the robot to get up to a standing position while barely bending their upper body forward as they were being raised (A method). Secondly, the robots were placed slightly further from the subjects, thus enabling the subjects to bend their upper body forward as they were raised to a standing position (B method). A surface electromyograph called SX230 (8ch type) was used to calculate the integral of the electromyogram signals (EMG integral) for each tested muscle. Following the experiment, subjects were surveyed regarding the usability/reliability of the robot and the subjective response associated with robotassisted standing transfer. 2. Ethical Consideration: All subjects were fully informed of the purpose of the study before consenting to participate in the study, and were fully aware that they could withdraw from the study at any time. They were also fully informed both orally and in writing about their right to privacy. Results The results of the present study can be summarized as follows: The EMG integral for each tested muscle was calculated for the first 13 seconds of a standing transfer. The EMG integrals for the biceps, forearms, and dorsum were markedly large when the A method was used to raise the subjects to a standing position. Furthermore, the A method caused greater muscle fatigue compared to the B method. According to the survey regarding the pain associated with a robot-assisted standing transfer, patients reported considerable pain in the forearms when the A method was used, which led to a decreased usability and reliability of the robot. On the other hand, although usability and reliability of the robot were relatively high when the B method was followed, the subjects reported some pain in the chest and the abdomen. Conclusions To sum up, the A method is not suitable for individuals with reduced lower limb strength because it causes great pain and strain in the arms. In contrast, muscle fatigue induced by the B method was relatively mild, and with a few modifications to the part of the robot which comes into contact with the user's chest and abdomen, the robot may have a potential to become auseful tool for assisting individuals in a standing transfer.
Cited by 0 works. doi:10.24795/nk002_001-012