ВПЛИВ ПРОТИТИСКУ, ЩО СТВОРЮЄТЬСЯ ТВЕРДИМ СЕРЕДОВИЩЕМ, НА ДЕФОРМІВНІСТЬ ЗАГОТОВОК ПРИ РАДІАЛЬНОМУ ВИДАВЛЮВАННІ

Roman Sivak, Катерина Іванівна Коцюбівська, Сергій Іванович Сухоруков · Journal of Mechanical Engineering and Transport · 2017

In the manufacture of solid and hollow parts with flanges of different thickness and diameters are used in most cases cold radial extrusion processes.In order to increase the marginal degree of forming and eliminating distortion of the flange promising to use a scheme of radial extrusion backpressure.In this study, we carried out the study of the process of radial extrusion of tubular billet of aluminum AD1 using backpressure created by the technical lead.For the construction of the load paths of characteristic points in the workpiece coordinate h, ms, eu calculated the stress-strain state using the finite element method.To test the effect of loading history on the plasticity of the value of used plasticity resource y was calculated at a volume stress. For this purpose, the criterion G. D. Delia that allows you to calculate the value y, as in the non-monotonic and monotonic loading at the complex.According to calculations, the most dangerous in terms of destruction is the point which lies at the end of the workpiece. At this point, the used resource of ductility was y = 0,6.The use in the process of radial extrusion backpressure as a plastic medium technological lead helped enhance the limit the extent of forming the blank and eliminate distortion of the flange.

Cited by 0 works. Open-access PDF

Authors