СПОСОБ ФОРМОВАНИЯ ЖЕЛЕЗОБЕТОННЫХ КОНСТРУКЦИЙ ПОСРЕДСТВОМ ОПУСКАЮЩЕГОСЯ БЕТОНА

Хафизов Тагир Мавлитович, Альберт Халитович Байбурин · Bulletin of South Ural State University series Construction Engineering and Architecture · 2019

The article describes a new method for molding reinforced concrete structures by means ofdescending concrete under various building conditions. The urgency of the problem is confirmed bythe absence of fundamental theoretical studies in this field of knowledge and justification of thefield of practical application of the new technology.The phenomenon of inhibition in the level of mechanization and automation of the buildingprocess for the molding of reinforced concrete structures at the construction site is disclosed. Proposalson its acceleration, reduction in cost, introduction of robotic automationare formulated; theywill provide a number of technical and economic advantages of the new method.A comparative analysis of the method of sliding formwork and the method of descending concretehas been carried out, technological problems, pitfalls in equipment; defects in the productionof work have been revealed.The advantage of this technology is in the fact that it issimpler and technologically efficientone, which in future will serve as a basis for developing a scientific methodology for system designin the construction of industrial and civil structures.

Cited by 0 works. Open-access PDF

Authors