ЗАМІНЕННЯ АРМАТУРНИХ СТАЛЕЙ ПРИ ВИГОТОВЛЕННІ ЗГИНАЛЬНИХ ЗАЛІЗОБЕТОННИХ ЕЛЕМЕНТІВ ПРЯМОКУТНОГО ПЕРЕРІЗУ ЗА НЕВИЗНАЧЕНИХ СТАТИСТИЧНИХ ХАРАКТЕРИСТИКАХ ВИХІДНИХ МАТЕРІАЛІВ
В.А. Бондарь, Л. В. Бондар, Н.М. Попович et al. · Scientific Bulletin of Civil Engineering · 2019
REPLACEMENT OF ARMATURE STEELS WHILE MANUFACTURING FLEXIBLE REINFORCED CONCRETE ELEMENTS OF RECTANGULAR SECTION AT UNCERTAIN STATISTICAL CHARACTERISTICS OF OUTPUT MATERIALS. According to the current recommendations, when replacing reinforcement in bent elements, the condition should be met when the total cross-sectional area of the reinforcement was equal to reinforcement for replacement. Numerical calculation using this method confirms the possibility of reducing the costs of reinforcement when it is replaced, using the developed technique. According to the current recommendations, when replacing reinforcement in bent elements, the condition should be met when the total cross-sectional area of the reinforcement was equal to or greater than the total area of the reinforcement to be replaced. In this case, the load, which leads to the appearance of calculated forces in a reinforced concrete element, is determined by the statistical characteristics of the reinforcement and concrete properties adopted in regulatory documents. In the case of a high production culture, the actual characteristics of the properties of reinforcement and concrete may differ from those adopted in regulatory documents. In this connection, there arises in this case a decrease in the consumption of reinforcement when it is replaced. The purpose of this work is to develop a method for calculating the replacement of reinforcement in the manufacture of flexible concrete elements with uncertain characteristics of materials. The algorithm for calculating the following. The minimum value of the bearing capacity of the bending element with the calculated resistance of the strength of concrete, reinforcement, the average value of the bearing capacity of the element on the average design values of the strength of materials, the actual bearing capacity of the element is determined. Defines standards for design and actual bearing capacity. According to these parameters, the design number of standards by which the average design bearing capacity differs from the minimum (uпр ), the actual average value of the carrying capacity from the minimum (uф) are calculated and compared. When uф > uпр, the design has a margin of safety that can be implemented when replacing valves. When this condition is met, a dependence is obtained for calculating the possible value of the element bearing capacity and the corresponding section of reinforcement for replacement. Numerical calculation using this method confirms the possibility of reducing the costs of reinforcement when it is replaced, using the developed technique.
Cited by 0 works.