An experimentally verified compact transient electro-thermal modeling procedure for power modules
Sabrine M'Rad, Bruno Allard, X. Jordà et al. · European Conference on Power Electronics and Applications · 2007
Ladders of RC-cell are usually used for compact thermal representation of power modules or assemblies. A large number of cells are considered in order to balance the intrinsic poor dynamic accuracy of the representation. However the number is limited by convergence problems in simulation. The RC-cells representation is also questionable in terms of relation to physical quantities. These limitations may be overcome using the so-called diffusive representation to build systematically a low-order but accurate thermal model of any assembly, and including thermal couplings. The paper intends to demonstrate how to build practically a diffusive model and assert its validation by experiment and through confrontation to finite-element simulations. A compact diffusive model comes as a state space model and main be easily implemented in circuit simulator.
Cited by 5 works. doi:10.1109/epe.2007.4417499
Authors
References
- Transient temperature measurements and modeling of IGBT's under short circuit
- Electrothermal modeling of IGBTs: application to short-circuit conditions
- Three-dimensional thermal modeling based on the two-port network theory for hybrid or monolithic integrated power circuits
- Electrothermal simulation of multichip-modules with novel transient thermal model and time-dependent boundary conditions
- Simple Approach to Approximation and Dynamical Realization of Pseudodifferential Time Operators Such as Fractional Ones
- Efficient Simulation of Coupled Circuit-Field Problems: Generalized Falk Method
- Comparison Between Simulated and Experimental Thermal Resistances of Power Devices Using an Specific Test Chip