A multi-mode extrinsic Fabry - Pérot interferometric strain sensor
T Liu, D Brooks, A Martin et al. · Smart Materials and Structures · 1997
This paper reports on the fabrication and evaluation of a multi-mode extrinsic Fabry - Pérot interferometric (EFPI) sensor which is capable of measuring both tensile and compressive strains. A scanning monochromator was used to measure the absolute cavity length of the EFPI sensor. Sensors of this type were embedded within a 16-ply carbon-fibre-reinforced epoxy composite and tested under quasi-static tensile and compressive loading conditions. Excellent correlation was observed between the EFPI sensor and a surface-mounted extensometer. The sensor system can operate in the strain range from -1 to 1% with an accuracy of better than 30 micro-strain. Preliminary results indicated that the sensor design was relatively insensitive to temperature in the range 38 - 180 . An analysis of the relationship between the insensitivity and the sensor geometry is also presented.
Cited by 32 works. doi:10.1088/0964-1726/6/4/011 Open-access PDF
Authors
References
- Discrimination between strain and temperature effectsusing dual-wavelength fibre grating sensors
- Simultaneous strain and temperature sensing with photogenerated in-fiber gratings
- Fatigue Behavior of Composite Laminate
- Fatigue behaviour of hybrid composites
- Strain/Temperature Discrimination Using Combined Fiber Bragg Grating and Long Period Grating Sensors
- A failure analysis of the micromechanisms of fracture of carbon fibre and glass fibre composites in monotonic loading
- Novel Bragg grating distributed-strain sensor based on phase measurements
- Multiplexed absolute strain measurements using extrinsic Fabry-Perot interferometers
- Simultaneous measurement of displacement and temperature using a low finesse cavity and a fiber Bragg grating
- Simultaneous Measurement of Strain and Temperature Using Optical Fiber Sensors: Two Novel Configuration