Tests of prototype SSC magnets
J. Strait, Bruce C. Brown, R. W. Hanft et al. · IEEE Transactions on Magnetics · 1988
Results are presented from tests of the third full-scale development dipole magnet for the Superconducting Super Collider (SSC) and from a retest of a 4.5-m model magnet of the same design mounted in an SSC cryostat. The 4.5-m magnet showed consistent quench performance between its original tests in boiling liquid helium in a vertical dewar and the current tests in forced-flow helium in a horizontal cryostat. Little or no retraining was observed over several thermal cycles. The full-length magnet required 12 quenches to train to its short-sample limit of 6800 A and displayed a reasonably stable quench plateau following training. Data are presented on quench behavior as a function of current and temperature, and on azimuthal and longitudinal loading of the coil by the support structure.>
Cited by 11 works. doi:10.1109/20.11329
Authors
- J. Strait
- Bruce C. Brown
- R. W. Hanft
- K. P. Koepke
- M. Kuchnir
- Paul M. Mantsch
- A.D. McInturff
- J.R. Orr
- J. Cottingham
- Per F Dahl
- M. Garber
- Arup K. Ghosh
- C. Goodzeit
- A. Greene
- J. C. Herrera
- E. Kelly
- G. Morgan
References
- Development of a 40 mm bore magnet cross section with high field uniformity for the 6.6T SSC dipole
- Construction of cold mass assembly for full-length dipoles for the SSC accelerator
- Tests of prototype SSC magnets
- Cryogenic Instrumentation of an SSC Magnet Test Stand
- Design, construction and test of a full scale SSC dipole magnet cryostat thermal model
- Full length prototype SSC dipole test results
- DEVELOPMENT OF A 40 mm BORE MAGNET CROSS SECTION WITH HIGH FIELD UNIFORMITY FOR THE 6.6T SSC DIPOLE