Измерение тепловых потоков на стенке ударной трубы
Ю.В. Добров, В. А. Лашков · Журнал технической физики · 2022
In this paper we carried out experimental study of a heat flux on the shocktube surface during passage of shock wave using a gradient sensor based on bismuth single crystal. The obtained experimental data were compared with numerical simulation results. It is shown that after passing through contact surface that separating the hot "plug" and pushing gas, the colder gas flow is mixed with the hot one. The heat transfer on the contact surface was evaluated.
Cited by 2 works. doi:10.21883/jtf.2022.09.52923.39-22 Open-access PDF
Authors
References
- The numerical computation of turbulent flows
- The wall boundary layer behind a moving shock wave
- Application of the gradient heat flux sensor to study pulsed processes in a shock tube
- Heat Flux Measurements by Sensors Based on Anisotropic Thermoelements in a Gasdynamic Experiment on Shock Tubes
- Analysis of large visualization datasets for thermographic studies in fluid dynamics
- Heat flux measurement at the initial phase of normal shock wave reflection using the sensor on anisotropic thermoelements
- Измерение тепловых потоков на стенке ударной трубы